Aluminum gas block for .750" AR15 barrels. This gas block has never been installed and comes with roll pin for gas tube. Attaches using 2 set screws.
ALL SALES FINAL. THIS IS NON RETURNABLE.

Aluminum 30mm single piece scope mount. Has been used once and comes with inserts for mounting 1 inch scopes.
ALL SALES FINAL. THIS IS NON RETURNABLE.

(1)

Fobus standard right hand paddle holster for the Smith & Wesson
M&P 9mm and 40 S&W pistols.  This is a new holster, never used.
Comes in original packaging.   ALL SALES FINAL.  THIS IS NON RETURNABLE.

Brazos Custom low profile magazine release button for all 1911 and 2011 framed pistols - NEW in factory packaging

ST Action Pro - 12 Gauge Trainer Dummy Rounds - Box of 25
ALL SALES FINAL. THIS IS NON RETURNABLE.

Gently used linear comp/muzzle break that came with a 5.56 / 223 pistol upper. Great fire ball producer.
ALL SALES FINAL. THIS IS NON RETURNABLE.

STI brand trigger for wide body STI 2011 modular framed pistols and clones.

This comp was aquired through Banks Bullets and used only for a few shots used in my YouTube video on compensators and the differences between them This is a 5.56 / 223 compensator with a 1/2 x 28 TPI pattern. Use a crush washer when installing to time it properly. ALL SALES FINAL. THIS IS NON RETURNABLE.

Aluminum 30mm single piece scope mount. Has never been installed and comes with inserts for mounting 1 inch scopes.
ALL SALES FINAL. THIS IS NON RETURNABLE.

Aluminum 1 Inch single piece scope mount. This has been used exclusively on my 6.8SPC hunting rifle. It is a very solid scope mount.
ALL SALES FINAL. THIS IS NON RETURNABLE.

STI Brand square hammer for 1911 and 2011 type pistols - NEW in original packaging

This comp was acquired for my compensator testing video and the differences between them This is a 5.56 / 223 compensator with a 1/2 x 28 TPI pattern. Use a crush washer when installing to time it properly.
ALL SALES FINAL. THIS IS NON RETURNABLE.

Used Ruger 10/22 barrel cut down to approximately 10 inches.  The muzzle has been threaded with the thread pattern of 1/2 x 28 in order to accept most all popular AR15 muzzle devices.  This barrel has some scratches from use (see pictures).  This barrel is legal to install on a pistol but should NOT be installed on a rifle unless it has registered as an SBR (Short Barreled Rifle).  ALL SALES FINAL.  THIS IS NON RETURNABLE.

This rifle scope was mounted on my 300 blackout, sited in and swapped
out for a lighter scope.  The scope has seen pretty much no use.  I
swapped it out for a lighter Leopold VX-1.  The
mount I used was a one piece mount with 1" rings
(this is a 1 inch tube).  Scope comes in original box.  ALL SALES FINAL.  THIS IS NON RETURNABLE.

This muzzle device is for the Advanced Armament line of 51T suppressor in the 5.56mm caliber. This compensator is new and has never been installed. This is a 5.56 / 223 compensator with a 1/2 x 28 TPI pattern.
ALL SALES FINAL. THIS IS NON RETURNABLE.

This rifle scope was used on my 6.8SPC rifle scope for one deer season. The scope has seen minimal use on my hunting rifle I use on TexasNative00. I have since changed to a new 3x9 from Redfield.

This is a slightly used Binary Firing System Trigger Pack.  It has been
installed in my SBR lower by fitting the base of the trigger assembly
per the instructions.  This was planned for hog hunting but it is
proving not to be the best option for hunting.  Therefore it is up for
sale at half the price.  Included are the shims for installing it in
your lower.  Also included is the 3 position selector, decal for the
lower and installation instructions.   ALL SALES FINAL.  THIS IS NON RETURNABLE.