 |
1) Pull down the takedown catch
2) Pull back the slide all the way to the rear and pull up the back side of the slide.
3) While holding the rear section of the slide up allow the side to move forward and come off the frame.
4) Remove the old recoil spring, Guide Rod and Buffer.
5) Slide over end of guide rod the Polymer recoil buffer, recoil spring, then Stainless Steel washer.
6) Compress the spring and Stainless Steel washer and install hex screw. NOTE: a tiny amount of thread locker is recommended.
7)
Install the new Captured Guide Rod Assembly and reverse steps 1-3.
* Due to the nature of this item and international regulations (ITAR) we can not sell to anyone that is not in the United States. All international orders will be canceled. To place an international order, the order must be placed through an exporter. Contact an exporter HERE
|
|
|
Fits perfect 
PPQ .22 captive rod & spring