High capacity magazine parts kit for the Walther PPQ 22lr that converts factory 10 and 10 rounds clips to 15 rounds.

Home > Magazine Upgrades >

Walther PPQ 15+1 High Capacity Magazine Upgrade

Walther PPQ | Walther PPQ-22 | PPQ22 | PPQ-22 | High Capacity | 22lrupgrades | high capacity magazine | magazine upgrade | magazine kit | 22lr magazine | magazine extension

Alternative Views:

This magazine upgrade you will get additional rounds in the factory 10 and 12 round mags. These modifications are not permanent and easily install in minutes. This upgrade will increase your Walther PPQ 22lr pistol magazine's capacity to 15 rounds. With one (1) in the chamber and 15 in the magazine, that's 16 rounds in the gun!

Please note you will not use the metal pin found in the factory follower. Most people use this pin to aid in loading the magazine. If you have the need for a load assist tool we have two options for you. The first uses the hole in the blue follower to push the follower down. You can find it HERE. The second works more like a traditional magazine loader and can be found HERE

PLEASE READ BEFORE PLACING YOUR ORDER
Choose whether or not you want your pistol to lock open on the last shot fired. The original magazine kits were sold with the Shockbottle follower THAT DOES NOT lock the slide open on last shot fired. The NicTaylor follower DOES lock the slide open on last shot fired just like the factory magazine.

MSRP: $16.95

Our Price: $12.95

Savings: $4.00

Shipping: Usually Ships in 1 to 2 Business Days
Part #: PPQ-MAG-UPGRADE

Follower:

Qty:

Installation Instructions

RESTRICTIONS

1. Remove factory basepad by depressing the spring retainer tab located at the bottom of the basepad. While depressing the spring retainer, slide off the factory basepad. CAUTION! This magazine spring is under tension and can "spring out" of the magazine tube along with other magazine parts.

2. Remove the factory spring. Remove the load assist button on the side of the factory follower. At this point you will be able to remove the factory follower.

3. Insert the HiViz follower and the included magazine spring.

4. Compress the magazine spring and spring retainer into the magazine tube and slide on the Basepad. Take note of the orientation of the spring retainer so that the side with the single button lines up with the hole in the basepad. The spring retainer will settle itself into the hole in the Basepad and lock it into place.